« Previous
Next »
Dental Materials
Volume 26, Issue 4
, Pages 368-379
, April 2010
Resin–dentin bonds to EDTA-treated vs. acid-etched dentin using ethanol wet-bonding
References
- . Adhesive phase separation at the dentin interface under wet bonding conditions. J Biomed Mater Res. 2002;62:447–456
- . Hybridization of the adhesive/dentin interface with wet bonding. J Dent Res. 2003;82:141–145
- . The mechanical properties of human dentin: a critical review and re-evaluation of the dental literature. Crit Rev Oral Biol Med. 2003;14:13–29
- . Resin bonding to wet substrate. 1. Bonding to dentin. Quintessence Int. 1992;23:39–41
- . The dentin substrate: structure and properties related to bonding. J Dent. 1997;25:441–458
- . Hybridization of dental hard tissues. Tokyo: Quintessence Publishing; 1998;
- . Differential effect of in vitro degradation on resin–dentin bonds produced by self-etch versus total-etch adhesives. J Biomed Mater Res A. 2006;77:128–135
- Effects of resin hydrophilicity on water sorption and changes in modulus of elasticity. Biomaterials. 2005;26:6449–6459
- Water sorption/solubility of dental adhesive resins. Dent Mater. 2006;22:973–980
- Effects of resin hydrophilicity on dentin bond strength. J Dent Res. 2006;85:1016–1021
- Net expansion of dried demineralized dentin matrix produced by monomer/alcohol saturation and solvent evaporation. J Biomed Mater Res A. 2006;79:349–358
- Bonding BisGMA to dentin – a proof of concept. J Dent Res. 2007;86:1034–1039
- Two-photon laser confocal microscopy of micropermeability of resin–dentin bonds made with water or ethanol wet bonding. J Biomed Mater Res B: Appl Biomater. 2009;90:327–337
- . Morphological and chemical characterization of bonding hydrophobic adhesive to dentin using ethanol wet bonding technique. Dent Mater. 2009;25:1050–1057
- Micropermeability of current self-etching and etch-and-rinse adhesives bonded to deep dentin: a comparison study using a double-staining/confocal microscopy technique. Eur J Oral Sci. 2008;116:184–193
- . Scanning electron microscopic investigation of human dentinal tubules. Arch Oral Biol. 1976;21:355–362
- . Regional variability in the permeability of human dentin. Arch Oral Biol. 1987;32:519–523
- . EDTA or H3PO4/NaOCl dentin treatments may increase hybrid layers’ resistance to degradation: a microtensile bond strength and confocal-micropermeability study. J Dent. 2009;37:279–288
- . Interfacial characteristics of resin-modified glass-ionomer materials: a study on fluid permeability using confocal fluorescence microscopy. J Dent Res. 1998;77:1749–1759
- Application of hydrophobic resin adhesives to acid-etched dentin with an alternative wet bonding technique. J Biomed Mater Res A. 2008;84A:19–29
- Durability of resin–dentin bonds to water vs. ethanol-saturated dentin. J Dent Res. 2009;88:146–151
- From dry bonding to wet bonding to ethanol-wet bonding: a review of the interactions between dentin matrix and solvated resins using a macromodel of the hybrid layer. Am J Dent. 2007;20:7–20
- . Heterogeneous distribution of single-bottle adhesive monomers in the resin–dentin interdiffusion zone. Dent Mater. 2001;17:277–283
- . In vitro performance of nano-heterogeneous dentin adhesive. J Dent Res. 2008;87:829–833
- . Stable adhesion to dentin. Combination of EDTA 3-2 (NH4/Fe) pretreatment and 2% 4-META/MMA-TBB resin. Shika Zairyo Kikai. 1990;9:841–849
- . EDTA treatment improves resin–dentin bonds’ resistance to degradation. J Dent Res. 2005;84:736–740
- Effects of HEMA/solvent combinations on bond strength to dentin. J Dent Res. 2003;82:597–601
- . Analysis of acid-treated dentin smear debris and smear layer using confocal Raman microspectroscopy. J Biomed Mater Res. 2002;60:300–308
- Infiltration/evaporation induced shrinkage of demineralized dentin by solvated model adhesives. J Biomed Mater Res B: Appl Biomater. 2007;80:156–165
- Effects of residual ethanol on the rate and degree of conversion of five experimental resins. Dent Mater. 2009;25:621–628
- . Characterization of photopolymerization of dental adhesives as a function of light source and irradiance. J Biomed Mater Res B: Appl Biomater. 2007;80:440–446
- . Relationship of solvent to the photopolymerization process, properties, and structure in model dentin adhesives. J Biomed Mater Res. 2007;80:342–350
- . Prevention of water contamination of ethanol-saturated dentin and hydrophobic hybrid layers. J Adhes Dent. 2009;11:271–278
- Influence of the chemical structure of functional monomers on their adhesive performance. J Dent Res. 2008;87:757–761
- Adhesion/decalcification mechanisms of acid interactions with human hard tissues. J Biomed Mater Res. 2002;59:56–62
- Comparative study on adhesive performance of functional monomers. J Dent Res. 2004;83:454–458
PII: S0109-5641(09)00512-0
doi: 10.1016/j.dental.2009.12.008
© 2009 Academy of Dental Materials. Published by Elsevier Inc. All rights reserved.
« Previous
Next »
Dental Materials
Volume 26, Issue 4
, Pages 368-379
, April 2010
