Dental Materials
Volume 23, Issue 3 , Pages 302-307, March 2007

HEMA diffusion from dentin bonding agents in young and old primary molars in vitro

  • Ayşegül Çetingüç

      Affiliations

    • Department of Pediatric Dentistry, Faculty of Dentistry, Hacettepe University, Ankara 06100, Turkey
  • ,
  • Seval Ölmez

      Affiliations

    • Department of Pediatric Dentistry, Faculty of Dentistry, Hacettepe University, Ankara 06100, Turkey
    • Corresponding Author InformationCorresponding author. Tel.: +90 312 305 22 80; fax: +90 312 324 31 90.
  • ,
  • Nilüfer Vural

      Affiliations

    • Specialist Research Center, Ankara University, Ankara, Turkey

Received 8 February 2005; received in revised form 4 June 2005; accepted 10 August 2005.

Abstract 

Objective

The objective of this study was to evaluate and compare amounts of HEMA diffusion from three dentin bonding systems in young and old primary molars at a remaining dentin thickness (RDT) of 1mm.

Methods

Occlusal cavities were prepared with RDT of 1mm in young and old primary molars. Chambers that contain 1ml of distilled water were attached to each tooth. The groups were treated with Total Etch+Syntac Single Component, Syntac Single Component and Clearfil SE Bond. Water eluates were analyzed by HPLC at 4min, 24h and 72h.

Results

The cumulative HEMA release amounts were significantly different among all groups (p<0.05). Acid-etching significantly increased pulpward diffusion of HEMA and young primary teeth presented higher dentin permeability.

Significance

Acid-etching significantly increases pulpward release of HEMA from dentin bonding systems in primary molar teeth. Young primary molars have higher dentin permeability; so the pulp should be protected with cavity liners in deep cavities. However, the dentin bonding systems can be considered safe for clinical use in primary teeth, even in deep cavities, since the released HEMA amounts are below the level of cytotoxicity.

Keywords: HEMA, Diffusion, Primary teeth, Monomer release, Dentin permeability

To access this article, please choose from the options below

Login to an existing account or Register a new account.

  • Purchase this article for 31.50 USD (You must login/register to purchase this article)

    Online access for 24 hours. The PDF version can be downloaded as your permanent record.

  • Subscribe to this title

    Get unlimited online access to this article and all other articles in this title 24/7 for one year.

  • Claim access now

    For current subscribers with Society Membership or Account Number.

  • Visit SciVerse ScienceDirect to see if you have access via your institution.
 

PII: S0109-5641(06)00039-X

doi:10.1016/j.dental.2005.08.013

Dental Materials
Volume 23, Issue 3 , Pages 302-307, March 2007